Details:
The relay block has two screw-type connectors that could be used to connect it to the Arduino board and to the load without any solder station.
The input connector receives the ground (GND) and the 5V required to power up the rele; the Enable command should be connected to any digital Arduino output line. When this line goes up, the rele' will be driven.
The output connector presents either the normal open contact (NO) either the normal closed contact (NC). Please refer to the pictures and schematics below for more details.
Technical characteristics:
User guide and assembly instructions
(click on the PDF icon, Acrobat Reader is required)
Warning: this product is targeted to hobby makers and not for professional use.
When purchasing, please specify if you need a kit (complete kit with spare components and the PCB to be soldered) or a complete mounted solution.
This relay stage was designed to enable any microcontroller based project (like Arduino boards) to drive loads working at maximum 250VAC, 6A.
The embedded driver made by a darlington transistor and some other passive components, lets it perfectly compatible with any digital 5V output line. Summarizing it can be connected to your Arduino output line like if it's a LED device.The relay block has two screw-type connectors that could be used to connect it to the Arduino board and to the load without any solder station.
The input connector receives the ground (GND) and the 5V required to power up the rele; the Enable command should be connected to any digital Arduino output line. When this line goes up, the rele' will be driven.
The output connector presents either the normal open contact (NO) either the normal closed contact (NC). Please refer to the pictures and schematics below for more details.
Technical characteristics:
- It works with 5V
- Maximum operating voltage at the Enable pin: 5V
- Single way relay with normal open and normal closed available contacts
- Maximum working voltage on the rele' rails: 250VAC
- Maximum working current on the rele' rails: 6A (AC)
User guide and assembly instructions
(click on the PDF icon, Acrobat Reader is required)Warning: this product is targeted to hobby makers and not for professional use.
When purchasing, please specify if you need a kit (complete kit with spare components and the PCB to be soldered) or a complete mounted solution.
Customers who bought this product also purchased...
